Veneered MDF, black oak, consists of a core of standard MDF with a layer of black oak veneer glued to one side. On the opposite side, either a matching black oak veneer is glued on, or a veneer of inferior quality and colour.
Facts
Technical description: Oak-veneered MDF, black oak / Oak-veneered MDF, black oak
Density: 0.7 g/cm³
Thickness tolerance: +/- 10 %
Veneer grade: A/B
Good to know
Veneered MDF is not suitable for outdoor use or in damp environments without a surface finish. Just like standard MDF, veneered MDF is easy to sand and work with.
MDF is a special type of wood-based material manufactured from wood industry waste mixed with adhesive. MDF is dimensionally stable and easy to work with, and is therefore often used for models and prototypes.
PLEASE NOTE! The colour of the veneer may vary from one delivery to the next. We cannot therefore guarantee the same shade every time.
Line and surface engraving
Veneered MDF, black oak, can be engraved using both line and surface engraving techniques. The material takes on a darker shade where it is engraved. The deeper the engraving, the darker the colour. The colour of the engraving, just like the colour of the wood, may vary from sheet to sheet.
With deep line and surface engraving, discolouration may occur around the engraved area. This is particularly the case with surface engraving. However, this can be easily removed by light sanding.
Surface engraving is not possible on sizes larger than A1.
Avoid burn marks
A protective film on the top and/or bottom can be selected when ordering, which helps to prevent the worst soot and burn marks from the laser. A-format sheets come with a protective film on the back as standard.
Wood grain
If you have any preferences regarding the wood grain and your design, please let us know by drawing an arrow in your file to indicate how we should orient the panel. Please also state in the comments field when placing your order that you have specific requirements in this regard.
Applies only to A-sizes.
Laser cutting
Top – Along the cut line, the wood will take on a slight dark discolouration. This can be avoided by applying protective film before cutting. The film can be selected as an option when placing your order.
Edges – The edges will turn dark and may leave marks. Excess ash can be wiped away with a slightly damp cloth, but the edges will remain dark afterwards.
Base – As standard, a protective film is applied to the base before cutting. Consequently, the base shows no visible burn marks. A small amount of soot may penetrate beneath the film, but this can be easily removed with fine-grit sandpaper. It is also possible to opt for double-sided adhesive tape to be applied if the cut-out is to be mounted on a wall or similar surface.
Finishing
MDF with oak veneer can be painted, just like standard MDF, but it is usually left untreated or varnished to protect the surface.
